COROLLA_EWD-H- Page 219 Saturday, May 12, 2007 2:58 PM
SRS
NOTICE: When inspecting or repairing the SRS, perform service in accordance with the following precautionary instructions
and the procedure, and precautions in the Repair Manual applicable for the model year.
D Malfunction symptoms of the SRS are difficult to confirm, so the DTCs e the most important source of information
when troubleshooting. When troubleshooting the SRS, always inspect the DTCs before disconnecting the battery.
D Work must be started more than 90 seconds after the ignition or starter switch assembly is turned to the
”LOCK” position (Ignition switch type) or the power switch is pushed to the ”OFF” position (Power switch type)
and the negative (–) terminal cable is disconnected from the battery.
(The SRS is equipped with a back–up power source so that if work is started within 90 seconds from
disconnecting the negative (–) terminal cable of the battery, the SRS may deploy.)
D When the negative (–) terminal cable is disconnected from the battery, the memory of the clock and audio system will be
cleared. So before starting work, make a record of the contents in the audio memory system. When work is finished,
reset the audio systems as they were before and adjust the clock. Some vehicles have power tilt steering, power
telescopic steering, power seat and power outside rear view mirror which are all equipped with memory function.
However, it is not possible to make a record of these memory contents. So when the work is finished, it will be
necessary to explain it to your customer, and ask the customer to adjust the features and reset the memory. To avoid
erasing the memory in each system, never use a back–up power supply from outside the vehicle.
D Before repair, remove the airbag sensor if shocks are likely to be applied to the sensor during repair.
D Do not expose the following parts directly to hot air or flame;
D Even in cases of a minor collisio
丰田COROLLA整车电路图手册(下册) 来自淘豆网www.taodocs.com转载请标明出处.